Magnetic Door Holder Fitting Instructions

To locate the two mounting holes in the door hold the contact plate centered against the magnet open the door and press against the transfer marking points on the armature base.

Magnetic door holder fitting instructions.

Place the button shaped magnet into the body section so that it sticks through the hole. Be released thus allowing the door closers to close the doors. We also sell hook auto door holder hinge pin door stop door holder overhead doorstop and door stop and hook. Place and center the door armature on the surface of the magnet with the two holes of the base aligned horizontally.

Mark the position for the keeper plate on the door. This may be something like a maglock or a yale door release for the installation all you re doing is connecting the door intercom to the screen and the screen with door release button to the door release mechanism meaning that you can see who s at the door and then press a button to release the lock on the door. Add the spring so the narrow end sits inside the button and the wide end will sit against the plate. Decide where the door holder will be mounted at least 650 mm from the door hinge.

Our products are available in satin nickel satin chrome polished chrome satin and polished stainless steel white polished brass and matte black finish. If you re trying to install and can t seem to get it open because its stuck. A short video showing how to properly install an electro magnetic door lock to your frame. You can choose to buy a door floor or wall mounted spring and overhead door stop.

Check the rubber ring is fitted before screwing the keeper plate to the door. Watch this video to show you how to open that stubborn magnetic doorstop. If you need a doorstop that not only prevents banging protecting walls skirtings brickwork but also holds open the door then look no further. Gently close the door and adjust the angle of the door armature so the base lays flat against the door.